WARNING

This product is intended to be used with e-liquid products containing nicotine. Nicotine is an addictive chemical.

Important Safety Information and Warnings

You have to make sure that your age is 21 or older, then you can browse this website further. Otherwise, please leave and close this page immediately!

WARNING: This product contains nicotine. Nicotine is an addictive chemical.

our_brand
  • about_smok
  • corporate_info
  • honor
products
  • DISPOSABLE
  • CLOSED SYSTEM
  • POD
  • POD MOD
  • ADVANCED MOD
  • PEN STYLE
  • BASIC KIT
  • TANK
  • COIL
  • ACCESSORIES
community
  • blog
  • new_and_event
store
compliance
  • pmta
  • tpd_file
  • combate_underag_use
support_link
  • faq
  • trouble_shooting
  • after_sales_service
  • product_verification
  • manuals_documents
  • ivps_tour
TFV8 Baby


TFV8 BABY & TFV8 BIG BABY

TWO EDITIONS FOR YOU

TFV8 Baby, which size is 1/3 smaller than the Cloud Beast - TFV8. Meanwhile, its airflow system: the 

bottom pair air-slots, the air chamber, the drip tip, are re-designed after precise calculations and 

optimizations. All those efforts ensure that TFV8 Baby is another Cloud Beast - a Baby Beast.

TFV8 Big Baby is the enlarged version based on TFV8 Baby, both its 5ml e-juice capacity and 

more vapors will let you enjoy pleasant vaping time.

Two editions, two experiences for you.

GLASS TUBE—MORE OPTIONS



SPECIFICATIONS


CONTRAST

TFV8(24.5*69mm) VS TFV8 BIG BABY VS TFV8 Baby(22*53mm)


SCHEMATIC DIAGRAM


TFV8 BABY BIG FAMILY

MATCH WITH BOTH THE TFV8 BABY AND TFV8 BIG BABY

DRIP TIP INTRODUCTION

Re-designed bottom pair air-slots, air chamber and drip tip provide you with powerful draw effects.


ADJUSTABLE AIRFLOW SYSTEM

Bring you an extremely open draw. Airflow can be adjusted freely by turning the ring at the base of atomizer.


TOP REFILL SYSTEM

Top refill system makes filling as easy as it gets.

Leak proof e-liquid slot can significantly solve leaking problem.



HOW TO BUILD THE RBA

1. Before starting make sure your hands are clean.

2. Taking RBA deck apart.


3. Installing and positioning the pre-wrapped coil. Place the coil between the posts and wrap the ends 

around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined 


up with the air hole, and also make sure the coil is NOT touching the base.

4. Cutting the ends of wire off.




5. Cutting a strip of cotton and make sure it’s not too much and not too less.

6. Inserting the cotton, and placing it in the middle.

7. Cutting the cotton at an angle and make sure it’s not too short and not too long.